GCr15 Steel Or Optical Glass Polyhedral Prism A Practical Selection Guide For Buyers

November 16, 2026

The most common question from first time buyers of polyhedral prisms is not about accuracy grade but about material. Should a calibration room order a GCr15 bearing steel prism or an optical glass prism? The answer depends on how the prism will be used, handled and stored, and the two options trade off in predictable ways.

What Each Material Brings

GCr15 bearing steel is a through hardening chromium steel. After hardening to HRC62-65 and lapping, the working faces hold flatness and reflectivity well and tolerate the knocks that happen on a workshop floor. Optical glass, typically with a refractive index near 1.5, is annealed and polished so that light passes through the body, which makes alignment visible to the operator.

PropertyGCr15 bearing steelOptical glass
HardnessHRC62-65Not applicable, brittle
Flatness of working face0.03 micrometreGrade 0 datum flatness 1 micrometre
Surface roughnessRa 0.025 micrometreRa 0.025 micrometre
Refractive indexOpaque, reflectiveAbout 1.5, transparent
Impact resistanceHighLow, chips on impact
Best environmentWorkshop, production lineLaboratory, optical bench
Typical price bandUSD 3000-5000 per pieceUSD 3000-5000 per piece

Choose Steel When Durability Leads

If the prism travels between machines, sits on a rotary table during setup, or is handled by operators wearing gloves, steel is the safer specification. The hardened body keeps edges intact, the polished face still reflects an autocollimator beam cleanly, and the 17mm to 20mm thickness gives a stable seat without excess weight.

Choose Glass When Visibility Leads

Optical glass wins when the operator must see the beam path or demonstrate refraction during setup and teaching. The transparent body also allows transmitted wavefront checks, and a 150mm diameter version suits large turntables where a wider reference face improves repeatability.

Accuracy Grade Decides Acceptance

Material choice affects service life, not accuracy class. Both materials are offered in Grade 0 with working angle deviation of plus or minus 1 arcsecond and Grade I with plus or minus 2 arcseconds. What changes is the inspection habit: steel prisms are usually checked with an autocollimator against a certified face, glass prisms are checked both mechanically and optically.

Ordering Checklist

Supplier Note

SPR-ing, a Shenzhen based manufacturer, produces both variants from 7 to 36 sides with a minimum order quantity of one piece, a monthly capacity of about 500 pieces and a delivery time of one to three weeks. Buyers comparing quotations should ask each supplier to state the working angle deviation and flatness figure in writing, because those two numbers, not the material label, decide whether the prism passes incoming inspection.

Get in touch with us
Contact Person : Payne
Tel : 18664971729
Characters Remaining(20/3000)