How 24 Sided And 36 Sided Polyhedral Prisms Tighten Rotary Table And Encoder Calibration

November 16, 2026

When a rotary table drifts by a few arcseconds between index positions, the error rarely shows up in a single spot check. It appears as scatter across the full circle. That is why calibration engineers have shifted from coarse prisms to dense ones, and why 24 sided and 36 sided polyhedral prisms now dominate new orders for rotary table and encoder verification.

The Arithmetic Behind Dense Referencing

A 24 sided prism presents a working face every 15 degrees, so a full revolution can be sampled at twenty four positions without moving the reference. A 36 sided prism goes further, offering 10 degree intervals and thirty six reference faces. More faces mean the error curve of the table is mapped rather than sampled.

PrismStep AngleReference FacesBest Fit
12 sided30 degrees12Coarse calibration, optical work
17 sided21.18 degrees17Odd division instruments
23 sided15.65 degrees23Laboratory turntables
24 sided15 degrees24Standard turntable certification
36 sided10 degrees36Encoder and dividing head verification

A Workable Calibration Sequence

The procedure below is the one most calibration houses follow with a 24 or 36 sided prism and an autocollimator.

With a 36 sided prism the same sequence returns thirty six data points in a single revolution, which is usually enough to separate a genuine table error from a measurement artefact.

Where The Accuracy Comes From

The prism itself must be better than the table it verifies. Production prisms are lapped so that working angle deviation stays within plus or minus 1 arcsecond at Grade 0, flatness of the working face reaches 0.03 micrometre, surface roughness holds at Ra 0.025 micrometre, and verticality between working surface and positioning surface stays within plus or minus 10 arcseconds. GCr15 bearing steel hardened to HRC62-65 keeps those numbers stable after repeated handling.

Mistakes That Invalidate A Reading

Supply And Lead Time

Dense prisms are stocked in smaller quantities than 7 or 12 sided versions, so lead time matters. Shenzhen manufacturer SPR-ing quotes one to three weeks for 24 sided and 36 sided polyhedral prisms, with a minimum order quantity of one piece, a monthly capacity of about 500 pieces, payment by L/C or T/T, and protective carton packaging with foam inserts.

For teams rebuilding an angle calibration capability this year, the practical conclusion is straightforward: specify a 24 sided prism for routine turntable certification, add a 36 sided prism when encoder scales need ten degree resolution, and insist on a face by face inspection report so the prism can serve as a working standard rather than a reference of unknown quality.

Get in touch with us
Contact Person : Payne
Tel : 18664971729
Characters Remaining(20/3000)